← 返回 JSSC 论文列表JSSC 2008第10期Other
A GSM/EDGE/WCDMA Adaptive Series-LC Matching Network Using RF-MEMS Switches
采用RF-MEMS开关的自适应系列LC匹配网络,提升多频多模移动电话链路质量。
插入损耗0.5dB, 谐波失真<-85dBc@35dBm, EVM<1%@27dBm, 电容调谐比~10
RF-MEMS开关自适应匹配网络多频多模阻抗校正系列LC电路
▸应用RF-MEMS开关构建5位可切换电容阵列,实现高线性、低损耗和大调谐范围
▸采用双极波形最小化RF-MEMS器件的平均偏置电压,减少介质充电效应
▸集成阻抗相位检测器和上下计数器,实现鲁棒的迭代控制
Abstract
To preserve link quality of mobile phones, under fluctuating user conditions, an adaptively controlled series-LC matching circuit is presented for multi-band and multi-mode operation. Following a bottom-up approach, we discuss the design of an RF-MEMS unit cell for the construction of a 5-bit switched capacitor array. To reduce dielectric charging of the RF-MEMS devices their average biasing voltage is minimized by applying a bipolar waveform with a small high/low duty-cycle obtained from a high-voltage driver IC. RF-MEMS capacitive switches are applied because of their high linearity, low loss, large tuning range, and easy control in the discrete domain. Application spe- cific RF-MEMS pull-in and pull-out voltage requirements are derived. An impedance phase detector is used to feed mismatch information to an up-down counter providing robust iterative control. The measured MEMS array capacitance tuning ratio is almost a factor 10. Module insertion loss is 0.5 dB at low-band and high-band. Harmonic distortion is less than 85 dBc at 35 dBm output power and the EVM, measured in EDGE-mode, is less than 1% at 27 dBm. The adaptively controlled module, connected to a planar inverted-F antenna, shows desired impedance correc- tion. For extreme hand-effects the maximum module impedance correction at 900 MHz is /55/53 /10.