← 返回 JSSC 论文列表
📄 下载 JSSC 原文 PDF
JSSC 2013第5期Clocking & PLLs90nmPLLVCO

A 90-nm CMOS 5-GHz Ring-Oscillator PLL With Delay-Discriminator-Based Active Phase-Noise Cancellation

提出一种基于延迟鉴频器的主动相位噪声消除技术,显著降低环形振荡器PLL的相位噪声。
5.1-GHz频率下1-MHz偏移相位噪声-105dBc/Hz,功耗增加<17%
环形振荡器相位噪声消除锁相环CMOS自适应校准
模拟前馈自适应相位噪声消除架构
在PLL带宽外提取并抑制环形振荡器的相位噪声
增益校准后对工艺、电压和温度变化不敏感
Abstract
Ring oscillators (ROs) provide a low-cost digital VCO solution in fully integrated PLL s. However, due to their supply noise sensitivity and high noise floor, their applications have been limited to low-performance applications. The proposed archi- tecture introduces an analog feed-forward adaptive phase-noise cancellation architecture that ex tracts and suppresses phase noise of ROs outside the PLL bandwidth. The proposed technique can improve the phase noise at an arbitrary offset frequency and bandwidth, and, after initial calibration for gain, it is insensitive to process, voltage, and temperat ure variations. An experimental fractional PLL, with a loop bandwidth of 200 kHz, is utilized to demonstrate the active phase-noi se cancellation approach. The cancellation loop is designed to suppress the phase noise at 1-MHz offset by 12.5 dB and reference spur by 13 dB with less than 17% increase in the overall power consumption at 5.1-GHz frequency. The measured phase noise at 1-MHz offset after cancellation is 105 dBc/Hz. The proposed RO-PLL is fabricated in 90-nm CMOS process. With noise cancel lation loop enabled, the PLL consumes 24.7 mA at 1.2-V supply.