⚡ 本页包含 AI 生成的分析内容,仅供参考
本文提出了一款完全集成的2×1双频段直接变频收发机,采用双模式分数分频器和噪声整形TIA,满足移动WiMAX (IEEE 802.16e) 标准。通过优化设计,TX输出杂散低于-60dBc,在40个样本中验证了对工艺变化的鲁棒性。
Masaomi Iwanaga, Kenichi Sami, Rui Ito, Junji Wadatsumi, Yuki Tsuda, Shoko Oda, Shunji Kawaguchi, Nobuyuki Itoh, Mototsugu Hamada Figure 25.4.4 shows the measured spurs at the TX output. Other than 1/3 fC, 2/3, 4/3, and 5/3 fC are also observed in the spectrum due to the non-linearity. However, the design is robust to the process variation, so that the levels of the spurs are below -60dBc in 40 samples. The results satisfy the spurious specification in mWiMAX with a sufficient margin. 25.4 Toshiba, Kawasaki, Japan Mobile WiMAX complying with the IEEE 802.16e standard is one of the emerging standards and is achieving world-wide penetration. Low-cost implementation is essential and single-chip implementation is a straightforward approach. However, there are many technical challenges such as floor-planning, signal integrity and scalability of analog/RF circuits in an SoC, as well as power reduction in scaled CMOS technologies. In this work, we have designed and fabricated a fully-integrat
Jun Deguchi, Daisuke Miyashita, Yosuke Ogasawara, Gaku Takemura,