← 返回论文列表 📄 下载原文 PDF  ISSCC 2012 · 24.3
ISSCC 2012Session 24 · 10GBASE-T & OPTICAL FRONTENDSWireline I/O

A 10Gb/s Burst-Mode Laser Diode Driver for Burstby-Burst Power Saving

⚡ 本页包含 AI 生成的分析内容,仅供参考

📋 论文概要

该论文提出了一种用于10Gb/s无源光网络(10G-EPON)的突发模式激光二极管驱动器(BLDD),通过在激光器关闭时实现94%的功耗降低,同时保持光发射功率低于-45dBm并满足晶体管击穿条件。该电路能在16ns内从关闭状态恢复到工作状态,比先前报道的突发模式发射器快46倍,从而实现了高效的逐突发节能。

💡 主要创新点

核心指标
10Gb/s数据率,94%功耗降低,16ns恢复时间,<-45dBm关态光功率
重要性
发表年份
ISSCC 2012

🏷 关键词

突发模式激光二极管驱动器10G-EPON功耗降低快速恢复

📄 原文摘要

A burst-mode laser diode driver circuit (BLDD) for 10Gb/s-class passive optical network (10G-EPON) systems reduces power consumption by 94% while the laser diode (LD) is in the off state. The off-state optical launch power is kept at less than -45dBm [1] while meeting the transistor breakdown condition. The BLDD recovers to the active state within 16ns, which is 46× faster than that of a previously reported burst-mode transmitter [2], and the fast recovery makes efficient burst-by-burst power saving possible. Reducing power consumption is a pressing issue for communications network systems [3]. This is especially true for PON systems, whose power consumption is proportional to the number of subscriber optical network units (ONU). To address this issue, sleep-based power saving has been discussed and investigated in IEEE 802.3az [4]. A simple approach for power saving is to shut down the transmitter while allocating no upstream optical burst [5]. However, since the

👥 作者与机构

Hiroshi Koizumi, Minoru Togashi, Masafumi Nogawa, Yusuke Ohtomo

NTT, Atsugi, Japan

分类:Wireline I/O · 年份:ISSCC 2012